1 |
Example: "Flow over a bump with Open Boundaries and passive tracers" |
2 |
==================================================================== |
3 |
|
4 |
default paths are (as used in testreport): |
5 |
set build_dir = ${cwd}/build |
6 |
set run_dir = ${cwd}/run |
7 |
set ROOT = ${cwd}/../../ |
8 |
|
9 |
Configure and compile the code: |
10 |
cd ${build_dir} |
11 |
${ROOT}/tools/genmake2 -mods ../code |
12 |
make depend |
13 |
make |
14 |
|
15 |
To run: |
16 |
cd ${run_dir} |
17 |
cp ../input/* . |
18 |
${build_dir}/mitgcmuv |
19 |
|
20 |
There is comparison output in the directory: |
21 |
results ( absolute path: ${run_dir}/../results ) |
22 |
|
23 |
Comments: |
24 |
The input data is real*8. |
25 |
|
26 |
This experiment is a channel with topography and four open |
27 |
boundaries. Salinity is not dynamically active in this experiment |
28 |
(linear equation of state with sBeta=0). Different kinds of open |
29 |
boundary values are used: zonal (x-)velocity U is prescribed at all |
30 |
open boundaries with values that are read from data files (specified |
31 |
in data.obcs); meridional (y-)velocity V is set to zero on all |
32 |
boundaries, and temperature to tRef(z), both in obcs_calc.F, this is |
33 |
the default behavior; at the western boundary, salinity values are |
34 |
used for salinity and one passive tracer in the same way. Salinity is |
35 |
set to sLev at all other boundaries, while a (nearly) homogeneous |
36 |
v.Neumann condition is applied to the passive tracer (the latter is |
37 |
the default in obcs_calc.F), with a relaxation (using pkg rbcs) in |
38 |
the Eastern part of the channel. Open boundary parameters are set in |
39 |
data.obcs. |